Recommended Drill Bit And Thread Tap For Tailgate Assist Application
Question:
I ordered a new tail gate assist and would like to replace the old one, I was wondering if theres a way to remove The thread where the bolt goes on on the tailgate and replace it with the new one
asked by: Zaia
0
Expert Reply:
To remove the old threading and replace it, I recommend you use a drill bit and tap in the size M12 X 1.25. You will need to determine the diameter you wish to have as the replacement and order that kit. Obviously this will require you to match a new bolt to the new threaded diameter.
expert reply by:
Jason S
0
![Jason S](https://images.etrailer.com/static/images/catg/people/1044_tn.jpg)
Product Page this Question was Asked From
DeeZee Tailgate Assist Custom Tailgate-Lowering System for Dodge Trucks
- Lift Supports
- Truck
- Tailgate Assist
- DeeZee
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Progressive Dynamics 2000 Watt Transfer Switch Good Choice for Replacing Xantrex Pro
- Q&A: Weight Distribution Adjustments For Hauling A 2020 ATC Toy Hauler
- Article: Most Popular Wheel Bearings
- Q&A: Lithium Battery Compatibility With Progressive Dynamics Pure Sine Wave Inverter With Transfer Switch
- Q&A: Can Progressive Dynamics 2000 Watt Inverter Mount in Compartment With Lithium Batteries
- Q&A: Recommended Inverter For Powering TV and Coffee Pot While Not Hooked Up To Shore Power
- Q&A: Recommended 50 Amp Transfer Switch To Accommodate Shore Power, Generator Power, And Inverter Power
- Q&A: Will Progressive Dynamics Pure Sine Wave Inverter Charge Batteries
- Article: How to Measure for Trailer Hitch Drop
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Tie Down a Canoe To a Roof Rack
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size