Is There A Standard When Installing Rack'Em Heavy Duty Stake Pocket
Question:
HI, I need a whole mess of these puppies for a 22foot flatbed and want to know what spacing you suggest for instance I suppose three or four per end, and HOW many feet between them down the sides?
asked by: Mike G
Expert Reply:
When installing the stake pockets like part # PK-BSP, there is no standard installation. You will want to make sure you have enough to secure the loads you plan on carrying.
I called my contact at Rack'Em and they told me if you are planning on using them for tie-downs then you will probably want to use more of them for that use but if they are for walls on a truck then you can use 3 or 4 per 8-ft section. Again, this is up to you and depends on how these are to be used. It is always better to have more and not need them than to find out later you do not have enough.
Product Page this Question was Asked From
Rack'Em Heavy Duty Stake Pocket for Flatbed Truck or Trailer - Bolt On - Steel - Qty 1
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Stake Pockets
- 2 x 4 Stake Pocket
- RackEm
more information >
Continue Researching
- Shop: Rack'Em Heavy Duty Stake Pocket for Flatbed Truck or Trailer - Bolt On - Steel - Qty 1
- Video: Review of Rackem Tie Down Anchors - Trailer Tie-Down Anchors,Truck Tie-Down Anchors - PK-BSP
- Search Results: weld on hinge
- Shop: Buyers Products Spring Latch - 3" Long x 1-3/4" Wide - Zinc Plated
- Shop: Ramp Door Hinge - 8-3/16" Long - 1" Pin Diameter - Steel
- Video: Demco Trailer Stake Pocket Spare Tire Carrier Review DM15850-52
- Search Results: tongue box
- Search Results: weld d ring
- Search Results: shackle
- Search Results: weld on
- Search Results: clevis
- Search Results: ratchet straps
- Shop: Trailer Weld-on Stake Pocket - 6 Gauge
- Video: Optronics Trailer Lights - Tail Lights - STL59RB Review
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 11 Diodes - Clear Lens
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 9 Diodes - Red Lens
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Video: Bulldog Trailer Jack BDPQM1900 Review
- Q&A: Availability of Replacement Grease Seal Part 30624
- Q&A: Tips for How to Identify a Trailer Axle
- Q&A: How Can I Identify an Axle Without a Sticker?
- Shop: Gooseneck Hitch
- Article: Where to Position the Trailer Axle?
- Shop: Transmission Cooler
- Shop: Trailer Wiring
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Q&A: How To Determine Proper Axle Placement On Single Axle Trailer
- Q&A: Hanger Spacing Recommendations for a Triple Axle Trailer with 25-1/4 inch Springs
- Video: TruRyde Bearing Kit for #84 Spindle Installation
- Q&A: Installing Leaf Springs on Single Axle Trailer