Installation Of An Electric A-Frame Jack On Trailer with 4 Inch On Center Triangular Bolt Pattern
Question:
My 2014 Tango has a 4inch O/C triangular bolt pattern. Will this match? Thanks
asked by: Dixon G
0
Expert Reply:
I went out into the warehouse to measure that jack mounting flange for you. Unfortunately, the Electric Jack w/ Footplate - Drop Leg - A-Frame - 25-1/8" Lift - 3,500 lbs - Black, # EJ-3520-BBX, is only a fit for the standard 3 inch on center bolt pattern. You most likely will need to drill holes for a standard jack or weld the jack in place for fit.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Q&A: Recommended Electric Trailer Jack For A 2018 Jayco Whitehawk
- Article: Best Camper Jacks
- Q&A: Hole To Hole Dimensions For Replacement I-Beam Jack Bracket # LC349975
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Electric Trailer Jack Not Working With Fully Charged Battery
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: Recommended Bearing Kit For 2,000 Lb Boat Trailer Axle
- Q&A: Recommended Weight Distribution System To Tow An ATC Game Changer 2513 Travel Trailer
- Article: Determining Trailer Tongue Weight
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Article: How to Measure for Trailer Hitch Drop