Dimensions Of Replacement Anchor Plates For B&W Biker Bar Motorcycle Tie-Down System
Question:
Hello. Im planning to purchase steel mounting plates to install under my trailer floor to add support to the biker bar system. I would like to know the exact dimensions of these backing plates that are part of the biker bar setup. Thanks
asked by: Chris
0
Expert Reply:
The Replacement Anchor Plates for B&W Biker Bar Motorcycle Tie-Down Systems - Qty 2, # BWMC2305 are 4 inches by 6 inches and 1/4 inch thick. See the attached picture for further help of holes 3/4 and 1 inch on center from edges.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Replacement Anchor Plates for B&W Biker Bar Motorcycle Tie-Down Systems - Qty 2
- Accessories and Parts
- Motorcycle Tie Down Straps
- Tie Down Anchors
- Motorcycle Anchor Parts
- Plates
- B and W
more information >
Continue Researching
- Q&A: What Size Hardware Comes with Replacement Anchor Plates for B&W Biker Bar Motorcycle Tie-Down System
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Airbags for a 2019 Chevrolet Colorado with Diesel Engine
- Article: How to Choose a Battery Charger
- Q&A: Replacement Anchor Plates for B&W Biker Bar Motorcycle Tie Down
- Q&A: What is the Difference Between the B&W Biker Bars BWMC2301 and BWMC2303
- Q&A: Do the B&W Bike Bars All Use the Same Base
- Q&A: How to Wire an Electric Winch
- Q&A: Does The B&W Biker Bar Require Two Anchors For Installation
- Article: Can You Flat Tow a Ford Bronco
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Hitch and Lock a Trailer
- Article: How Much Solar Power Do I Need For My RV?