Troubleshooting Trailer Wiring Where Driver Side Trailer Lights Don't Illuminate
Question:
I have a 2016 big tex gooseneck trailer an all running an tail lights work. On the driver side my turn signal an break light dont. You have any ideal what the problem may be
asked by: Clintis
0
Expert Reply:
When it's one side of a trailer that has not lights it's almost always a ground problem. Check the condition of the grounds on the trailer. Make sure the lights are grounded to a clean metal surface whether they ground through their hardware or they have wires that run back to the trailer frame.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations