Equalizer Weight Distribution System Recommendation for 5,000 lb Trailer
Question:
I have a 2016 Ram 1500 with factory tow package towing a Winnebago 19ft Micro Minnie. The trailer weighs 3100lbs Dry and will probably weigh no more than 5000lbs loaded. I like the Fastway E2 and Equalizer weight distribution hitches because they seem simple and have few parts. Which ones will work for me? Also, are you able to install the 2-5/16 ball?
asked by: Esteban
Expert Reply:
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
For a 5,000 lb trailer the tongue weight would end up being between 500 and 750 lbs. For an Equalizer system good for that you would want the # EQ37060ET for if the tongue weight is closer to the lower end (below 600 lbs) or the part # EQ37100ET if closer to the higher end.
The hitch balls come with the kits but we cannot install them for you.
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Products Referenced in This Question
Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 6,000 lbs GTW, 600 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 400 lbs
- 500 lbs
- Equal-i-zer
more information >
Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 10,000 lbs GTW, 1,000 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 800 lbs
- 900 lbs
- Equal-i-zer
more information >
Product Page this Question was Asked From
Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 6,000 lbs GTW, 600 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 400 lbs
- 500 lbs
- Equal-i-zer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Are Replacement Spring Bars Available For The Curt TruTrack 4P Weight Distribution System # C74RV
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Help Finding a Hitch Extension For Towing a Car Trailer Behind a 2023 Ford F-250 With Truck Camper
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Q&A: Recommended Weight Distribution Hitch For Towing a 2023 Scamp 16 Travel Trailer
- Article: Determining Trailer Tongue Weight
- Q&A: Lighter Weight Spring Bars for the Blue Ox TrackPro Weight Distribution System
- Q&A: Comparing SumoSprings Helper Springs For the Rear Suspension on a 2024 Ford Bronco
- Q&A: Best Weight Distribution With Sway Control for Scamp 13 Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Difference Between 2-Point and 4-Point Sway Control on Weight Distribution Systems