How Does Brake Controller Install in 2008 Chevy Suburban

Question:

I am trying to find the generic wiring guide for the Tenosha trailer break to a Chevy Suburban. I found one for a Dodge but have had no success in finding the same diagram for the Suburban. Any help in locating this would be greatly appreciated.

asked by: Anthony G

Expert Reply:

On your 2008 Chevy Suburban there is a set of wires under the dash that are used for hardwiring a brake controller to. If you check out the help article I attached you will see exactly how to find and use this harness. I also attached an install video that will walk you through the process as well.

For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes.

expert reply by: Jameson C