Are Load Resistors Required When Installing LED Mini Utility Light For Lighting Running Boards
Question:
If I were to use 2 of these per door to act as exterior door convenience lighting/running board lighting, would a relay be necessary? Any additional information would be appreciated. Thank you.
asked by: Nathan S
0
Expert Reply:
You should not need load resistors when you install the Uni-Lite LED Mini Utility Light, part # UCL11CKB.
The biggest problem that requires load resistors is when incandescent bulbs are replaced with LEDs and the new lights do not draw enough power so the vehicle thinks there is a bulb out. This should not be the case when you are installing these mini lights.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Uni-Lite LED Mini Trailer Utility Light w/ Grommet - Submersible - 2 Diodes - Round - Clear Lens
- Work Lights
- Utility Lights
- Exterior Lights
- Interior Lights
- Round
- Recessed Mount
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Can The Mounting Flange for Optronics Uni-Lite Trailer Lights # A11PB Replace A Rubber Grommet
- Article: Replacement Automotive Lighting
- Q&A: How to Measure a Pin Box to Determine What Sidewinder would Replace it
- Q&A: Longest 5th Wheel Pin Box Based on Front Bolt Holes to King Pin
- Q&A: Can The Command Electronics LED Light 328-ET003184CWM Be Hooked Up To A Dimmer Switch?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Amperage of Brake Magnets and Size of Wire Used To Connect 7-Way Trailer Plug To Electric Brakes
- Q&A: Should Actual Trailer Weight or Gross Trailer Weight Be Used for Pivot Point on Fulton Fold-Away Kit
- Q&A: Replacement Screen for Ventline V2394 RV Roof Vent
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: Trailer Jacks
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Tire Sizing