Is There Drilling Required to Install Bulldog Trailer Jack BD171401
Question:
Do you have to drill the 1/2 inch hole for the swivel lock pins to go into?
asked by: Elvis C
0
Expert Reply:
There would be no drilling required to install the Bulldog Jack part # BD171401. The pin that controls the swivel inserts only into the portion of the bracket that welds to the trailer frame.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Round, Snap-Ring Swivel Jack - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: What Is The Difference Between The Dexter Oil Hub 008-430-03 & The Dexter Trailer Hub 8-288-3UC1?
- Article: Best RV Roof Vents
- Q&A: What are the Dimensions of Trailer Jack Support Plate # BD003135
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Recommended Replacement Electric Brake Assembly for 3500 Pound Dexter Axle, 10 x 2-1/4 Inch Drum
- Q&A: Replacement 2-1/2 Inch Round Marker Light on Triton Trailers Elite WCII Personal Watercraft Trailer
- Q&A: Grease Seal Recommendation for Dimensions 1.375 ID and 1.983 OD
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Maintenance Schedule
- Article: Basics of Tie Down Straps
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs