Replacement Jack Solution for Trailer that Needs 1-7/8 inch Diameter Tube Jack
Question:
I am looking for a tongue jack to put on a rebuild job of an old trailer. It must have an outside diameter of no more than 1 7/8. It will go up through the bottom of the tongue and bolt to the underside of the tongue. I would appreciate any help.
asked by: Ken S
Expert Reply:
None of the jacks we offer have tube dimensions that would be small enough to fit the bottom support plate on your trailer that is 1-7/8 inches in diameter.
The best recommendation I could make would be to install a new bottom support plate like part # BD003135 so that you could use a jack like the etrailer Jack part # TJA-5000S-B that you referenced. For a foot plate you would want part # JF-99.
Products Referenced in This Question
Bulldog Jack Support Plate - A-Frame - 2-1/3" Diameter Hole
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Plates
- Bulldog
more information >
Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- etrailer
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Phoenix USA Baby Moon Hubcap - 10-1/2" Diameter - Stainless Steel - Qty 1
- Q&A: Replacement Electric A-Frame Trailer Jack with 1-7/8 Inch Outer Tube Diameter
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - White
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White
- Search Results: maxxfan 7000k
- Search Results: maxxfan
- Search Results: maxxfan 5100k
- Search Results: baby moon hubcaps
- Q&A: Replacement for a Bargman L100 Airstream 1967
- Shop: Electric Jack w/ Footplate and 7-Way Plug - A-Frame - 25-1/8" Lift - 3.5K - Black
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - White
- Shop: SmartPlug RV Power Cord and Inlet Upgrade Kit - Stainless Steel Inlet - 30 Amp - 30'
- Shop: SmartPlug RV and Marine Power Inlet - 30 Amp - Stainless Steel
- Shop: RV Power Cord
- Shop: RV Electrical
- Search Results: baby moon hubcap
- Q&A: Recommended A-Frame Jack With Close To A 1-7/8 Inch Diameter
- Q&A: Mounting Hole Size for A-Frame Trailer Jacks
- Q&A: A-Frame Trailer Jack with an Outer Tube Diameter of 2 Inches
- Q&A: Replacement Caster Wheel for 1-3/4" Tube
- Search Results: jack caster 1 3 4
- Q&A: Mounting Bracket for DL22530 A-Frame Trailer Jack