Replacement Jack Recommendation for 2005 Forest River Sandpiper 5th Wheel
Question:
What replacement jack to get for a 2005 forest river sandpiper 5th wheel
asked by: Lucas E
Expert Reply:
In order to pick out a direct replacement for the landing gear on your 2005 Forest River Sandpiper we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Stromberg Carlson Tandem Landing Gear Set # LG-183708. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # LG-183708.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement. From previous experience with Forest River trailer it is very likely you have the 17-1/2 inch dimension.
Products Referenced in This Question
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Replacement Landing Gear for VMC900R
- Q&A: Replacement Motor for LCI Power Stabilizer Jack Model 1917771
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Q&A: Replacement Landing Gear for 1993 Coachmen Catalina
- Q&A: How to Know if Landing Gear Set # RVLG-8HDL Will Fit 2001 Sunnybrook 31BWFS
- Q&A: Replacement Power Distribution Panel for Iota IDP-240
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams