Can Urethane Sealant be Used to Install a Vent in a Van with a Fiberglass Top
Question:
I have a 1985 conversion van with fiberglass top. Will the Urethane caulk work for installing this vent VP-543SP? The previous vent had a 6inch metal collar installed but I assume Ill have to remove it to fit the new vent.
asked by: Nancy
0
Expert Reply:
Yes, you can use installation kit # 344270KITW or another similar sealant. Just make sure to clean away any previous sealant and materials prior to using it so there won't be any negative reactions with incompatible chemicals.
expert reply by:
Michael H
0
Products Referenced in This Question
Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White
- Accessories and Parts
- RV Vents and Fans
- Vent Install Kit
- LaSalle Bristol
more information >
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 2-3/8 Inch
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Continue Researching
- Article: Replacement Automotive Lighting
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Availability of Brake Line Fitting to go from 1/8 inch Male NPT to 3/16 Female FIF
- Q&A: Replacement Al Ko 10k Brake Calipers and Brake Pad Recommendation
- Q&A: Replacement Front Landing Gear Leg for Lippert Ground Control 3.0
- Q&A: Replacement Operator Mechanism for MaxxAir MaxxFan 4751KS
- Q&A: Availability of Dexter Leaf Spring 072-079-00 for 8,000 lb Trailer Axle
- Q&A: How To Install MaxxFan Dome Roof Vent On Thin Metal Roof
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Trailer Maintenance Schedule
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review