Spacing of Bolts that Hold Mounting Plates to Ultra-Fab Scissor Jacks # UF48-979006
Question:
Can you tell me the bolt spacing for the bolts that mount the jack itself to the mounting plate? My travel trailer has welded mounting plates, so Im trying to find a jack that I can just remove those two bolts and attach the new jack to the old mounting plate.
asked by: Mitchell
0
Expert Reply:
I went out to the warehouse to measure the Ultra-Fab scissor jacks # UF48-979006 for you. The bolts that hold the mounting plates to the jacks are spaced 2 inches apart on center. I have included a picture showing this.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Ultra-Fab Ultra Scissor Jack - 24" Lift - 6,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 6001 - 7000 lbs
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Are There Hub Caps for 14 inch Trailer Wheels
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Replacement Surge Actuator For A Dexter DX 12.5 Surge Actuator
- Q&A: Where to Measure on a Scissor Jack to Determine if it Will Fit on a Trailer
- Article: Trailer Wiring Diagrams
- Article: Embrace Winter Wanderlust: Celebrate Holidays with Harvest Hosts
- Q&A: Is Capacity of Stabilizing Scissor Jacks Combined or For Individual Jack
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: How to Investigate Break Away Disconnect Issue on the Blue Ox Patriot 1
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Awning Strut or Support for Carefree Awning
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Converting Your RV Water Heater to Tankless
- Article: Anti-Rattle Devices