Replacement Wheel and Crank Assembly Availability for Bulldog Rack and Gear Jack
Question:
does the wheel swivel on this jack and can I get a replacement wheel and I also need a handle that goes on the crank
asked by: Mike
0
Expert Reply:
If you have a Bulldog Rack and Gear jack and need to replace the post assembly so that you have a swiveling wheel the product you need is the part # BD018006.
The handles aren't available separately but we do have replacement gearbox and crank assemblies like part # BD019141. But at this point you are essentially buying an entire Rack and Gear jack since those are the two main components so you may as well just get the part # BD165412.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Rack-and-Post Assembly w/ Steel Wheel for Bulldog Rack-and-Gear Jacks - 21"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Assembly
- Bulldog
more information >
Continue Researching
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Q&A: Recommended Hub For Mobile Home Axle That Uses L68149 and LM67048 Bearings
- Q&A: Spacing Between Hangers With Slipper Springs for 8,000 lb Axles and Hanger Kit
- Q&A: Are 14 Inch Trailer Available With 6-Bolt Pattern For 10,000 Lb Trailer
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Lug Nut Torque Spec for a 1/2 Stud with Coned Lugs on a 15 in Steel Wheel
- Article: Trailer Hitch Receiver Sizes
- Q&A: Parts Needed To Switch From Dual 30LP Propane Tanks To a Single Propane Tank On RV Camper
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams