Where is Grease Zerk Fitting of Ultra Fab Jack UF38-944037
Question:
Product description says grease Zerk on lower stem. Where is it?
asked by: John B
0
Expert Reply:
If you check out the picture I attached you will see the zerk fitting pointed out on the # UF38-944037. Basically you have to pull the outer tube cover down and it will be visible.
You can also see it in the video I attached at the 2:00 mark.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Troubleshooting Ultra-Fab Electric Jack Has no Power When Lifting Trailer
- Q&A: Holders for Storing 4-Way and 7-Way Plugs on Trailer
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Jacks
- Article: Enjoy The 2024 Eclipse With Harvest Hosts
- Q&A: Recommended Weight Distribution System To Tow An ATC Game Changer 2513 Travel Trailer
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Replacement Toggle Switch for Ultra-Fab Jack that Lifts But Won't Lower
- Q&A: Recommended Electric A-Frame Jack for Travel Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Best Camper Jacks
- Article: 2023 Holiday Must Haves
- Article: How to Measure for Trailer Hitch Drop