How to Pick Out Landing Gear for a Trailer and Determine if Brackets would Need to Move
Question:
What front landing jacks would i use for 2006 alpenlite 5th wheel 32 agusta, the bracket on the bottom was bolted to the jack and then welded to the frame to remove it i will have to grind the welds and install and weld a new bracket on. thanks for your help
asked by: Steve P
Expert Reply:
In order to pick out a direct replacement for the landing gear on your 2007 Desert Fox 38U we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Products Referenced in This Question
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Water Heater To Replace Atwood Gc6aa/10E
- Q&A: Is Dometic 6-Gallon RV Water Heater DMC74FR Best Option For Tanked Water Heater
- Q&A: Do Lippert Carpet Protectors for RVs with Slide Outs # LC134993 Permanently Install
- Q&A: Battery Box that Can Fit Trailer Frame
- Q&A: Hopkins Electronic LED Smart Level Mounting Instructions For A Motorhome
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Article: Best Bike Racks for Electric Bikes
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Does Solar Panel Type Really Matter?
- Article: Best Landing Gear
- Article: What To Look For When Buying Ratchet Straps