Location of Blue Wire for Installing the Tekonsha Wiring Harness TK22113 in 2015 Dodge Durango
Question:
Instructions for TK22113 state Route 12 gauge blue wire to vehicle body harness connection point. Connect to vehicle’s green wire, using supplied using butt connector. Do you know where this infamous connection is physically located on a 2015 Dodge Durango?
asked by: Bob
0
Expert Reply:
I spoke with my contact at Tekonsha and he informed me that the wire is in the passengers front wheel well behind the fender liner. There is a connector that it is attached to on one side.
I attached a drawing diagram that shows you where it is.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter - 7 Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is There an Air Lift Helper Spring Kit For a 2022 Dodge Durango R/T?
- Q&A: Should 30 Amp Breaker be Used When Installing Installation Kit For Trailer Brake Controller
- Q&A: Is Drilling Required To install Draw-Tite Hitch For 2021 Kia Forte
- Q&A: Will the Air Lift Kit AL60824 Fit a 2017 Dodge Durango Citadel Anodized Platinum AWD
- Q&A: Trailer Hitch and 7-Way Wiring for 2020 Dodge Durango
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What To Look For When Buying Ratchet Straps
- Article: How to Choose the Right Trailer Hitch Class
- Article: What Do I Need To Tow A Trailer?
Mike
6/26/2020
Bob, did you ever find this green wire??? I’ve been all over the passenger side inner fender and there is no green wire ready to butt connect anywhere. I’ve even cut away a ton of the factory wire loom on both sides of the connector trying to locate it.