Wiring Recommendation for the Pollak Metal 7-Pole # PK12703
Question:
i was looking at the pollak 7 way metal female for my 1986 k10. i have the insert that is installed in the actual rear bumper. ill need this then also the adaptor that plugs into the rear harness to connect to the 7 way
asked by: Gordon C
0
Expert Reply:
For the Pollak Metal 7-Pole # PK12703 there isn't a harness that plugs into the back of it, but we do offer a jacketed 7-way wiring harness by the foot. For that you would want the part # DW04914-1. It's sold by the foot so you would need to order a quantity of it in the length you need.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Hitch Adapters and Extenders
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Recommended Wet Bolt and 2-1/4" Shackle Strap Kit for Tandem Axle Trailer
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: Replacement Dexter Grease Seal for Seal Part K71-386-00
- Article: Troubleshooting Brake Controller Installations
- Q&A: Trailer Hitch and 7-Way Wiring Harness for Freightliner M2