Solution for Reducing Harshness In Ride Quality of Timbren Kit TFTTT350F
Question:
In the booklet that comes with the Timbren TFRTT350F it says to have the bump stop set a 1 1/2 inch to a 1 inch above the peg. After I installed the bump stops and lowered the bed the bump stops were resting on the pegs. Which makes for a really rough ride. Any ideas?
asked by: Colton L
0
Expert Reply:
Remove the spacer between the jounce spring and the mounting bracket. That will give you more clearance so that the suspension can move a few inches before activating the Timbren.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Extra Heavy Duty
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Components of Firestone Air Suspension Systems
- Q&A: Can a Larger Antenna Extend The Range on VueSMART RV Trailer Backup Camera?
- Q&A: Will Timbren Springs Fit On 2013 Ford F-250 Without The Raised Bump Stop Above The Axle Tube?
- Q&A: Which Timbren Kit HD or Lighter Duty for 2016 Ford F-350 That Hauls Campers Frequently
- Q&A: Trailer Hitch for a 2016 Ford F-550 Cab and Chassis with Dump Body
- Q&A: Comparing Timbren TFR250SDJ and TFR350SDJ for a Ford F-250/F-350
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Will the Timbrens Help with Worn Out Leaf Springs on a 2005 GMC Sierra 1500
- Article: Gooseneck Trailer Hitch Information and Review
- Q&A: Should I Get Loadlifter 5000 Or 7500 For Towing A 15K Fifth Wheel
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Replace an RV Roof Vent Cover