Troubleshooting Electric Over Hydraulic Brake Controller That Keeps Running
Question:
Every now and then when I hook up my trailer and push the brake pedal. The brake motor starts to run and will not stop. I unplug the 7 pin connector and it still runs. I have to wait until trailer battery go dead and pump motor stops. Then I can plug in 7 pin connector back in and it works fine. Only happens about once a week. ???
asked by: Scott B
Expert Reply:
Since you came from a Dexter Actuator I can help you troubleshoot the problem. If you do not have a Dexter unit let me know and I will be glad to see if I can help you out. Most issues are related to wiring or ground problems. Since it sounds like this is not a new installation I don't think it is an issue with the incorrect brake controller in your vehicle. You do want to make sure you are using a brake controller like part # 90885 that is designed for electric over hydraulic systems.
Here is the troubleshooting instructions for a Dexter actuator you can check out.
1. Verify that the trailer and tow vehicle are wired according to the electrical schematic shown in “Electrical Requirements”.
2. Re-bleed the trailer brakes. Any air in the trailer brake system causes brake delay
3. if the trailer is equipped with drum brakes, re-adjust the drum brakes to the trailer manufacturer's recommended running clearance.
4. Trailer wiring that is too small can cause slow response
5. Slow response can be caused by brake line restrictions. The trailer brake lines must be at least 3/16” in diameter. Steel tubing is preferred over flexible hoses.
6. Check to see if the white ground wire runs directly to the tow vehicle ground. IT MUST NOT BE GROUNDED TO THE TRAILER ONLY. IT IS IMPORTANT THAT THIS GROUND WIRE RUNS DIRECTLY TO THE TOW VEHICLE'S BATTERY GROUND. NO EXCEPTIONS.
7. Detach all wires from the Dexter Axle E/H unit leaving only the blue, black, white and yellow wires. It is important that the unit is disconnected from any other wires going to the towing vehicle or breakaway switch and breakaway battery. Failure to do so may result in a faulty test.
8. Using a 12 volt battery, connect the white wire to the negative (-) terminal of the battery.
9. Connect the black wire to the positive (+) terminal of the battery. The motor should not run. If the motor runs, the unit may be defective.
10. Leave the white wire connected to the negative (-) terminal of the battery.
11. Connect the blue and black wires together to the positive (+) terminal of the battery.
12. The motor should run and the unit should pressurize
13. If this does not occur, the unit may be defective.
14. Leave the white wire connected to the negative (-) terminal of the battery.
15. Connect only the yellow wire to the positive (+) terminal of the battery.
16. The motor should run and the unit should pressurize.
17. If this does not occur, the unit may be defective.
18. If the unit checks OK, reconnect the wires leading to the trailer plug and repeat steps 9 through 14 at the trailer plug. If you do not get the same results as before, the problem is in the trailer wiring or the electronic brake controller.
Using the breakaway system to troubleshoot a unit that is not operating correctly.
1. With a fully charged breakaway battery and trailer plug disconnected, pull the breakaway switch on the trailer.
1. If the unit runs and builds pressure, the breakaway system is functioning properly.
2. If the unit runs and builds pressure when the breakaway switch is pulled but will not function under normal operating conditions, the problem mot likely is a defective in-cab controller or defective wiring between the tow vehicle and Dexter E/H actuator.
3. If the unit runs but will not build pressure when breakaway switch is pulled, the Dexter E/H unit may be defective.
4. If the unit does not run, measure the DC voltage between the white wire and the yellow wire. If the voltage is less than 12 volts, either the breakaway switch or the breakaway wiring is defective.
5. After completing the above steps, reset the breakaway switch and reconnect the trailer plug.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Dexter DX Series Electric Over Hydraulic Brake Actuator for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- 1600 psi
- Disc Brakes
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Brake Pads for Dexter Disc Brakes - 10,000 lbs and 12,000 lbs - Semi-Metallic - Qty 4
- Shop: Caliper Rebuild Kit for 10,000-lb and 12,000-lb Dexter Disc Brakes
- Shop: Disc Brake Caliper for Dexter 10,000-lb to 12,000-lb Hydraulic Disc Brakes
- Shop: Disc Brake Caliper Piston for Dexter 10K & 12K Hydraulic Disc Brakes
- Shop: Dexter DX Series Electric Over Hydraulic Brake Actuator for Disc Brakes - 1,600 psi
- Search Results: dexter brake actuator
- Shop: Fifth Wheel Hitch
- Shop: Dexter BrakeRite SD Adapter for Ford/Chevy Integral Brake Controllers
- Shop: Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Q&A: Troubleshooting Dexter Electric Over Hydraulic Actuator that Runs When Disconnected
- Shop: Brake Controller
- Video: Diamond RV 2 USB Port Charging Station Review
- Shop: RV Jack Pads
- Q&A: Wiring Diagram for Trailer Breakaway Kit
- Search Results: electric over hydraulic adapter
- Q&A: 2022 GMC Sierra 3500 Factory Brake Controller Does Not Work with Dexter EOH Actuator
- Q&A: Is 2021 GMC Sierra 3500 Compatible With Travel Trailer With Electric Over Hydraulic Brake System
- Q&A: Will Integrated Brake Controller of 2020 GMC Sierra 3500 Work with Dexter Brake Actuator
- Q&A: Troubleshooting Intermittent Trailer Disconnected Message with Factory Brake Controller on Ford
- Q&A: Does 2022 Chevy Silverado Need Adapter For Dexter DX EOH Actuator & Factory Brake Controller
- Search Results: sw6del
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Base Plate for Tow Bar
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Video: Roadmaster Rear Anti-Sway Bar Installation - 2012 Winnebago View Motorhome
- Shop: Vehicle Sway Bars