Are Tow Hooks Removed When Installing Draw-Tite Hitch # 41015 On 1997 Toyota Land Cruiser
Question:
I have a few quick questions regarding the drawtite class III trailer hitch for a 1997 toyota landcruiser. Does it fit without having to remove the spare tire which is stored underneath the vehicle? Can I install it and still retain the factory tow hooks on the rear of the vehicle or do they have to come off to have it installed?
asked by: Greg P
Expert Reply:
You will not need to remove the spare tire when installing the Draw-Tite Class III 2 Inch Hitch # 41015 on your 1997 Toyota Land Cruiser. You will need to remove the tow hooks when you install the hitch, but you will reinstall the tow hooks on the vehicle. When you reinstall the tow hooks you will switch the location of the tow hooks. The passenger side tow hook will go on the drivers side and the drivers side tow hook will go on the passenger side.
I am sending a link to the installation instructions of the Draw-Tite hitch.
If towing with the hitch you will also need Curt Ball Mount # C45010, Pin And Clip # PC3, Tow Ready 2 Inch Hitch Ball # 19247, and the Curt Wiring Harness # C59236.
Products Referenced in This Question
2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Tow Ready
more information >
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/4" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- CURT
more information >
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span
- Hitch Pins and Clips
- Standard Hitch Pin
- Fits 2 Inch Hitch
- Fits 2-1/2 Inch Hitch
- 5/8 Inch Diameter
- 4 Inch Span
- Draw-Tite
more information >