Where to Measure to Determine Correct Bearing Buddy for Trailer Hub
Question:
Bearing Buddies, how should I measure my wheels for the correct Bearing Buddy?
asked by: Wade D
Helpful Expert Reply:
In order to pick out the correct bearing buddy you will need know the pilot hole of your hub. To do this, remove the wheel and tire and remove the grease cap from the center of the hub. Usually it is a metal cap that is just lightly hammered into place. Use a screwdriver to pry off the cap.
Clean the grease off and measure the opening. I have included a video demonstrating the Bearing Buddy.
The Bearing Buddies # BB1980A-SS that you referenced are for hubs with a 1.98 inch hub bore.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A-SS w/ Auto Check - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Possible Bearing Buddy that Could Fit Hub with Seal 12194TC
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Replacement Stainless Steel Kodiak Trailer Brake Kit For 6,000LB Axle With 6 On 5-1/2 Bolt Pattern