Replacement Post and Foot Recommendation for 1987 Bulldog Model 160 Jack
Question:
I have a 1987 boat trailer with a Bulldog Model 160 trailer jack. Will BD018308 fit? Thanks,
asked by: Bill
0
Expert Reply:
I checked with my contact at Bulldog and you can use the Rack-and-Post Assembly, # BD018520, with a model 160 rack and gear jack. The part # BD018006 is not a confirmed fit so I cannot recommend it.
expert reply by:
Jameson C
0
Products Referenced in This Question
Replacement Rack-and-Post Assembly w/ Footplate for Bulldog Rack-and-Gear Jack - 23-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Assembly
- Bulldog
more information >
Product Page this Question was Asked From
Replacement Rack-and-Post Assembly w/ Steel Wheel for Bulldog Rack-and-Gear Jacks - 21"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Assembly
- Bulldog
more information >
Continue Researching
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Q&A: Recommended Hub For Mobile Home Axle That Uses L68149 and LM67048 Bearings
- Q&A: Spacing Between Hangers With Slipper Springs for 8,000 lb Axles and Hanger Kit
- Q&A: Are 14 Inch Trailer Available With 6-Bolt Pattern For 10,000 Lb Trailer
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Lug Nut Torque Spec for a 1/2 Stud with Coned Lugs on a 15 in Steel Wheel
- Article: Trailer Hitch Receiver Sizes
- Q&A: Parts Needed To Switch From Dual 30LP Propane Tanks To a Single Propane Tank On RV Camper
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams