Size of the Mounting Hole of the Brophy Rope Ring Tie-Down Anchor # RR09
Question:
What size is the mounting hole?
asked by: Jonathan L
0
Expert Reply:
The mounting hole on the Brophy Rope Ring Tie-Down Anchor # RR09 is 3/8 of an inch in diameter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy Rope Ring Tie-Down Anchor with Plastic Pan - Bolt-On - Surface Mount - 1,000 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1000 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Continue Researching
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Activating 12-Volt Accessory Circuit to 7-Way on 2004 Chevy Silverado 2500
- Q&A: Where to Locate the Factory Brake Controller Plug in a 2022 Ford Explorer with Factory 7-way
- Q&A: Fully Extended Height Of The Ark Drop Down Croner RV Stabilizer Jacks
- Q&A: Dimensions of ARK DDS750 RV Stabilizer Jack Mounting Plates
- Q&A: Stabilizer Jack Recommendation for 4 Corners of Hi-Lo Travel Trailer
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Boat Trailer Showdown: Bunks vs. Rollers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop