Is Cut Trailer Wiring Difficult to Reattach
Question:
If the has brakes and some one cut the wires is hard to fix
asked by: Robert M
0
Expert Reply:
I hope they didn't cut the wires as a way to get revenge on you...
It's not hard to reattach trailer wiring though. Just use solder and electrical tape or butt end connectors. If the wires were cut the colors would match right up as well as the lengths.
I attached a help article that has diagrams and more info on trailer wiring in general.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
3" Round Trailer U-Bolts (Qty 2)
- Trailer Suspension Parts
- U-Bolts
- Camper
- Car Hauler
- Utility Trailer
- 5200 lbs - 7000 lbs
- Round Axle - 3 Inch
- 1/2 Inch Diameter
- 7 Inch Long
- Dexter
more information >
Continue Researching
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Article: Trailer Maintenance Schedule
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: Troubleshooting 6 Gallon Atwood Water Heater Not Working on Electric But Works on LP
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Q&A: Best Weight Distribution for a V-Nose Trailer with Short Frame Distance from Coupler to Body
- Q&A: Troubleshooting Surge Brakes Locking Up When Moving Forward
- Article: Best Camper Jacks
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box