Replacement Inner Arm and Bushing Kit for Roadmaster Sterling Tow Bar

Question:

Hi, I have a Roadmaster Sterling tow bar I believe I have bent one of the inner rods as it will not slide in or out with out a lot of force. I believe my serial # is 2433, it has treaded end on shaft at yoke , will the RM 910660 replacement shaft work and if so do I need the RM-910003-40 seal kit as well?, Thanks in advance

asked by: Billy S

Expert Reply:

If the serial number on your Sterling tow bar is 2433 then replacement arm # RM910660 will not work because it is designed for models with serial numbers between 11841 and 27824. But if the number you have given is missing a digit then the arm will fit (since at the lowest the number would be 12433 if it was missing a digit). The serial number is located up near the shank where the two arms come together.

I do recommend also replacing the bushings with # RM-910003-40 because if the arm is damaged it could have also caused damage to the bushings.

expert reply by: Michael H