Dimensions of Hangers Included with Single-Axle Trailer Hanger Kit for 2" Slipper Springs APS6SE

Question:

I am looking for dimensions for the APS6SE spring hanger kit. Overall sizes and mounting hole size and spacing would be appreciated. Thanks

asked by: Timm

Expert Reply:

The front hangers in kit # APS6SE are # 721584. They measure 3-3/4 inches from the top to the center of the mounting hole. The hole is 9/16 inches in diameter. The holes that are in the top are not for bolting the hanger. They are there to mount the hangers using button welds. Very few hangers are designed to be bolted on.

The rear hangers in the kit are # 721585. They measure 5-1/6 inches tall from the top to the center of the 9/16 inch diameter hole. It also features the 2 holes for button welds.

The inner width of each is slightly more than 2 inches since they are designed for use with 2 inch wide slipper springs. Both of the hangers are approximately 4 inches front to back. For hanger spacing I have included a picture that shows the possible spacing using specific leaf springs.

expert reply by: Michael H