Mounting Hole Dimensions On RoadMaster 6-Wire Trailer Connector
Question:
Could you please send me the mounting dimensions for the 910030-7. thanks
asked by: Larry C
1
Helpful Expert Reply:
The center-to-center distance of the mounting holes on the RoadMaster 6-Wire Trailer Connector, part # RM-910030-7 is 3-3/4 inches.
The mounting holes can accommodate up 1/4 inch bolts when installing.
expert reply by:
Jeffrey L
1
Product Page this Question was Asked From
RoadMaster 6-Wire Trailer Connector - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Roadmaster
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Comparing etrailer and Blue Ox Baseplate Kits For A 2023 Jeep Gladiator
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Base Plate Kit for a 2022 Jeep Wrangler Rubicon Using a Nighthawk Tow Bar
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Does Bumper Need to Be Removed to Install Blue Ox Base Plates on a 2017 Ram 1500
- Article: Tow Bar Wiring: Which Wiring Kit is for You?