Dimension of Thickness for Optronics Rubber Mounting Ring A45GB
Question:
Can I mount the A45GB rubber mounting ring in a hole that is 4 1/2 inches round in a panel that is 3/4 inch thick3/4 inch plywood? Thankz
asked by: A. T
0
Expert Reply:
The Optronics rubber mounting ring # A45GB will fit into the hole that is 4-1/2 inches round, but the thickness of the mounting ring is 1-1/16 inches in depth. So if your plywood panel accommodates this amount of depth, then this rubber mounting ring will work well for you.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Rubber Grommet for 4" Round Trailer Lights - PVC
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 4 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Bearing Kit For 2,000 Lb Boat Trailer Axle
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: Is a Gap on Either End of Cross Tube Acceptable for Draw-Tite Hitch Installation on 2023 F-150
- Q&A: Weight Capacity of Dexter P-12 Model SLR Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Compatibility of Optronics Trailer Tail Light # STL43RB With Trailer 4-1/2-Inch Opening
- Q&A: Replacement Backup Light for Peterson 426E on Motorhome
- Q&A: Four-Wire Option w/ Backup Light For Thinline LED Trailer Tail Light
- Q&A: Power Awning Conversion Kit for Carefree Fiesta BN3N4
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller Installation: Starting from Scratch
- Article: 2023 Best Gifts for Outdoor Enthusiasts