Will the Stromberg Carlson Trailer Jack Fit Standard 3 Bolt Mounting Flanges on Trailer Frames
Question:
The mounting bolt pattern on this jack is in a round configuration if my camper has a triangle configuration mounting plate will this jack fit the triangle mounting plate holes? Thanks
asked by: Danny
Expert Reply:
Yes, the mounting flange of the Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black, Item # JET-5000 you referenced is designed to fit the standard 3 bolt mounting flange that you trailer has. This will measure right at 3 inches between each adjacent hole with a bit of wiggle room since the holes are typically slotted.
I attached an install video for this jack for you to check out as well.
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 4001 - 5000 lbs
- Electric Jack
- 23 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Trailer Wiring Diagrams
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: How to Charge a Dump Trailer Battery
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them