Replacement Handle Recommendation for a Bulldog 190 Series Square Tube Jack
Question:
Hello, I have a Bulldog jack. Square tube, side winder. The label says it is a 5k lift, 7K static jack. Is your cat # BD500171 handle the correct replacement for my Jack? Also, is my Jack considered a 5K or 7K. Do they rate them by static or lifting capacity? Thanks
asked by: Tony
Expert Reply:
Sounds like you have a 190 series Bulldog jack like the part # BD190751 as it matches your description. The replacement handle is the part # BD500171 that you referenced then.
They are typically rated by lifting capacity as that is what jacks are used for.
Products Referenced in This Question
Bulldog Square Jack w/ Footplate - Fixed Leg - Sidewind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Product Page this Question was Asked From
Replacement Crank Handle Assembly for Bulldog Sidewind Jacks - 8-1/2" Radius
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Bulldog
more information >
Continue Researching
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Q&A: Dust Cover/Cap Solution for Harbor Freight Trailer
- Q&A: Best Replacement for Coach Steps 725-0041
- Q&A: Oil Seal for 10K Quality Axles with Seal 27438
- Q&A: Trouble Finding the Brake Controller Wiring Port on a 2019 Chevy Blazer
- Q&A: Where Is Factory Trailer Brake Controller Port On 2021 Chevrolet Tahoe W/ Factory Tow Package?
- Q&A: Where is the Factory Trailer Brake Controller Port On a 2022 Chevrolet Tahoe
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Measure a Trailer Axle
- Article: Brake Controller Installation: Starting from Scratch
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub