Parts Needed to Flat Tow a 1992 Ford Ranger
Question:
can it be flat towed 4 on the ground
asked by: Bill H
Expert Reply:
You are going to have to check you owners manual to determine if your vehicle can be flat towed. Due to it's age I couldn't find an electronic copy online and our other resources we use don't go back that far either. At worst you would most likely end up having to install an axle disconnect to allow the vehicle to be flat towed.
For a base plate kit you would want the part # 431-1 which is confirmed to fit your truck.
In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle. The most popular compatible tow bar is the Falcon 2, # RM-520. For safety cables you can use # RM-643. The coiled design helps keep the cables off of the ground.
For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.
And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BRK20169, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.
Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.
I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.
Products Referenced in This Question
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Standard
- Roadmaster
more information >
RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs
- Safety Cables
- Coiled Cables
- 68 Inch Long
- 6000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Fixed Arms
- Tow Bar Base Plate
- Fixed Draw Bars
- Roadmaster
more information >