Can Edge EZ Module Be Stacked with Edge CTS 2 Programmer
Question:
Can a Edge EZ tunner be hooked up with a Cts 2 edge tunner on a 2007 dodge
asked by: Shawn
0
Expert Reply:
You do not want to stack programmers on your vehicle. Doing so will cause damage as they are both designed for use with a stock PCM.
The Edge EZ module has three levels:
Level 1: 25 Horsepower - 50 Foot Pounds of Torque
Level 2: 45 Horsepower - 75 Foot Pounds of Torque
Level 3: 65 Horsepower - 150 Foot Pounds of Torque
But can only provide that power on a stock tuned PCM.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge EZ for Dodge Cummins 5.9L, 24V, Common Rail
- Performance Chip
- Performance Tuners
- Tuner Only
- No Display Screen
- Yes - California Approved
- EZ
- Edge
more information >
Continue Researching
- Q&A: Toggle Switch Positions on the Edge EZ Programmer 30204
- Q&A: Replacement Switch and Cable Recommendation for Edge EZ Programmer # EP30204
- Q&A: How to Install the Edge EZ for Dodge Cummins 5.9L 2003-2004 Dodge Ram
- Q&A: Which Switch Position of Edge EZ Module Determines Which Power Level
- Q&A: Can an Air Tank and External Air Hose be Added to an Air Lift WirelessAIR Compressor System
- Q&A: Can the Edge EZ Programmer be Used without the Toggle Switch
- Q&A: Edge EZ Programmer For 2000 Dodge Ram With 5.9L Cummins Diesel Engine
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop