Assembling the Hopkins Go Gear Console Plus Interior Cargo Organizer
Question:
The console did not come with any instructions and there are two rectangle plastic pieces with Velcro on each side. Where do they go? Or could you email me the diagram? Thanks
asked by: Orlo B
Helpful Expert Reply:
I went out to the warehouse to determine how those 2 rectangular pieces fit into the rest of the console organizer # CNSLPLUS-BLA. There are outside pockets on the front and rear of the organizer that open at the bottom. The shorter piece goes in the front pocket and the taller one in the back with the Velcro pointed down to mate with the Velcro on the insides of the pockets. These pieces help provide structural rigidity.
Product Page this Question was Asked From
Hopkins Go Gear Console Plus Interior Cargo Organizer
- Car Organizer
- Consoles
- Seat Console
- 5 Inch Tall
- 11-1/2 Inch Wide
- 11 Inch Long
- Black
- Hopkins
more information >
Continue Researching
- Q&A: Product Weight of the BedSlide Sliding Truck Bed Tray
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is Lateral Stabilization Required for the Titan Hitch Extension for 2-1/2 inch Hitches When Towing
- Q&A: Truck-Bed Camper Troubleshooting For Tie-Down / Step Space Issue
- Q&A: What is Weight Difference Between Aluminum and Steel Torkflift Camper Tie Downs TLF2022A TLF2022
- Q&A: Is There Strength Difference Between Aluminum and Steel Torklift Tie Downs for 2022 Ford F-350
- Q&A: Best Truck Bed Camper Tie Downs for 2022 Ford F-350 Short Bed
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Stability Control for Heavy Duty Vehicles
- Article: 4-Step Guide to Installing RV Solar Power
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: How Long Can You Boondock in an RV?
- Article: Trailer Wiring Diagrams