To What Size Fuse Should Optronics Thin-Line LED Racing Light Kit Be Wired
Question:
What size fuse do I need to wire it to?
asked by: Cathy P
0
Expert Reply:
I spoke with my contact at Optronics about the amp draw of the Thin-Line LED Racing Lights # LS-108. He confirmed that each light will draw 0.08 amps, and as a set the lights will draw 0.16 amps.
With so little amp draw, you can tap these lights into whichever fuse works best for you.
If you need a fuse tap, you can use the Firestone Fuse Circuit Tap Kit # F2526.
expert reply by:
Victoria B
0
Products Referenced in This Question
Product Page this Question was Asked From
Optronics ThinLine LED Racing Light Kit w/ Harness and Power Switch - 12 Diodes - Oblong - Qty 2
- LED Strip Lights
- Rigid Light
- Exterior Light
- Hardwired
- 0 - 10 Inch Long
- White
- Optronics
more information >
Continue Researching
- Q&A: Recommended Roof Vent Upgrade for a Dometic EZ-Breeze
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Q&A: How Much Does the B&W Companion OEM 5th Wheel Hitch for Ram Towing Prep Package Weigh
- Article: Trailer Maintenance Schedule
- Q&A: Can OEM Hitch on 2021 Jeep Gladiator Be Replaced with Draw-Tite 76310
- Article: Trailer Wiring Diagrams
- Article: What Exactly is Tongue Weight?
- Article: What is Boondocking
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Charge a Dump Trailer Battery