Mounting Dimensions for the Stromberg Carlson Ladder LA-401
Question:
Need to know spacing for supports to attach ladder to rear of a 2016 Keystone Cougar 33res travel trailer can you provide? Thanks
asked by: Herschel
0
Expert Reply:
The side to side dimension of the # LA-401 mounting brackets is 11 inches measured on center.
The mounting brackets will end up being 13 inches from the edge of the roof as well.
So you would need to measure 13 inches from the edge of your trailer roof and then from there measure 11 inches on either side and you will know where this ladder would mount on your roof.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Exterior RV Ladder - Aluminum - 99-1/2" Tall - 250 lbs
- RV Ladders
- Exterior Ladders
- Aluminum
- 8 Feet Tall
- Silver
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement RV ladder for 2007 Monaco Diplomat
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Which Lift Kit Fits 2010 Forest River R-Pod 172 with Lippert 3,500 Torsion Axle
- Q&A: How Far Back Should Thule Mounting Feet Be Placed On a 2019 Toyota Highlander with Bare Roof
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: RV Pre-Departure Checklist