Will "Junior" Locking Stainless Steel Flush Door Latch Fit Trailer Door is Correct Hole Size Is Cut
Question:
I have an enclosed cargo trailer. Id like to ad a stainless flush mount latch so I can close it from the inside. Will one of your latches work if I cut out an appropriate size hole ?
asked by: John
0
Expert Reply:
All you would need to do to install the part # L1883 that you referenced is cut the appropriate sized hole. For this latch you would need a hole that measures 3-5/8" tall x 4-3/4" wide.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
"Junior" Locking Stainless Steel Flush Door Latch
- Trailer Door Latch
- Latches
- Flush Latch
- Stainless Steel
- Built In Lock
- 2-3/4 x 3-3/4 Inch Cutout
- Redline
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Replacement Trailer Lamp Lens # 1A-S-20
- Q&A: Which Brakes to Fit in Dexter 8-247 Hub and Drums
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Q&A: Replacement Kwikee Step Controller for Part 1800709 on 2017 Thor Windsport
- Q&A: Replacement for Kwikee Revolution Step 9010000464 on 2011 Winnebago Journey 40U
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Hub Recommendation for Dexter Hub 8-250
- Q&A: Replacing Trailer Actuator Buddy 32220 Reverse Solenoid on Triton Bass Boat Trailer
- Article: Car Camping Checklist
- Article: Will Flat Towing Blow Up Your Transmission?