Trailer Jack Recommendation for a Trailer with only 3 inches of Available Frame Space
Question:
i have very limited room to place a tongue jack, about 3 inches. can i Use U bolts and brackets to attach one of the weld on jacks?
asked by: Brian M
0
Expert Reply:
A swivel pipe-mounted jack like the Pro Series part # PS1401460303 can mount to a trailer frame and since the pipe that welds to the frame is only 2 inches wide it would fit on your trailer frame that only has 3 inches of clear space.
I attached a review video for this jack for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Trailer Wiring Diagrams
- Article: Pintle-Hitches
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Q&A: Replacement Conversion Kit For Motor For # 781005
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Will the Demco Brake Actuator # DM8202022 Work with Disc Brakes on a Boat Trailer
- Q&A: Recommended Cover for a Lance Truck Bed Camper Model 1010
- Q&A: Replacement Recommendation for TDE 46210 Hub
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch