How Thick of Metal is Used on the Bulldog Winch Winch Mount BDW20208
Question:
What is the gauge of the metal of this winch plate? Will it work with the rubicon 10th anniversary bumper and a Superwinch Synthetic Tiger Shark TS9500SR Winch? Thanks
asked by: Matt C
0
Expert Reply:
I spoke to my contact at Bulldog winch and he informed me that the # BDW20208 is 5 mm thick steel which is a little bit thicker than 3/16 of an inch. This is going to be very close to 6 gauge.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Winch Winch Mount - 10th Anniversary Edition OE Bumper - Jeep JK
- Accessories and Parts
- Electric Winch
- Mounting Hardware
- Plates
- Without Handle
- Bulldog Winch
more information >
Continue Researching
- Q&A: Install Instructions for Bulldog Winch Mount # BDW20208
- Q&A: Recommended Trailer Connector And Wiring Harness For 2014 Jeep Wrangler Unlimited With Tow Package
- Q&A: Will Bulldog Winch Mount Fit 2017 Jeep Wrangler Unlimited Rubicon Hard Rock
- Q&A: Does 3,500 lb Leaf Spring Need to Have Same Number of Leaves as Original
- Q&A: Recommended Axle Mounting Hardware for Square Axle
- Q&A: What's The Difference Between A TruXedo Elevate CS # TX24NV And FS # TX84NV Rack
- Q&A: Is Much Modification Needed to Install Bulldog BDW20208 on a 2017 Rubicon Recon Edition