Bestop Power Running Boards Work For Rear Doors But Not For Front Doors
Question:
My boards will net work with either front doors but will work with both rear doors???
asked by: Collin
Expert Reply:
I have attached the instructions for installation of the Bestop PowerBoard NX Motorized Running Boards, part # B7564115.
You will need to make sure the magnet and the sensor for each door is positioned so they mate up. If they are not aligned properly, the sensors will not be able to recognize when the door is open or closed. I recommend checking the alignment of the magnets and sensors to make sure they are positioned correctly.
You will also want to check the wiring connections for any signs of corrosion, or frayed, broken, or pinched wires.
If this system worked at one time but has stopped working, the batteries in the sensors for the running boards may need to be replaced. You would need CR2450 3 volt batteries. To replace the battery in each sensor you would need to do the following:
1. Remove the PowerBoard wire harness fuse that is next to the car battery.
2. Remove the two screws and the cover plate on the sensor. Slide out the circuit board and note
the orientation of the board. Replace the battery and slide the board back into the housing with its original orientation. Leave the vehicle door or doors open.
3. Reinstall the PowerBoard fuse and wait 30 seconds. The sensor is reprogramming its address
during this time.
4. Shut the door(s). Open and close the doors(s) to check for normal operation. If opening a door fails to operate the PowerBoard, open the appropriate door and remove the PowerBoard fuse. Wait 30 seconds and the reprogramming will repeat. Reinstall the fuse and check for normal operation.
