Can a LED Identification Light Replace a Non-LED Light on a Trailer
Question:
i have a trailer with standard lights the middle light under the trailer is broke can I replace with a LED light Sealed, 3-Light Truck, Trailer Identification LED Light Bar, Black Base, 50inch Lead, 9 Diode -Red Optronics Trailer Lights or do i need to stick with standard non-led
asked by: Keith
0
Expert Reply:
If you wanted to replace the broken identification bar on your trailer with an LED version like the part # MCL84RB you certainly could. An LED setup will last longer, be brighter and will draw less amperage so it would be a great option.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 17L x 1-1/2W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Picking Out Replacement Grease Seal for # 174253TB
- Q&A: Grease Seal to Replace Part Number 174253tb
- Article: Trailer Wiring Diagrams
- Q&A: Replacing 6-Pin Trailer Connector For 7-Way Blade Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How to Choose Replacement Latch for Tack Room
- Q&A: No 12 Volt Power to Trailer Connector on a 2002 Chevy Silverado
- Q&A: Is Tire Size 20.5 x 8-10 the Same as a 205/65-10 Trailer Tire
- Q&A: Warranty of Tekonsha Activator IV Trailer Brake Controller
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Maintenance Schedule