Distance from Mounting Hole to Bottom of Yates Y-Style Bow Stop for Boat Trailers # YR4Y22-3
Question:
Im looking at your YR4Y22-3 2X2 What is the measurement from the bottom of the stop to the 3/8th hole? The bottom meaning. The bottom of the Y
asked by: J. W
0
Expert Reply:
Yates Y-Style Bow Stop for Boat Trailers # YR4Y22-3 measures approximately 1/2 inch from the center of the 3/8 inch hole to the bottom of the bow stop. There is about 1/8 inch of runner from the bottom of the hole to the bottom of the bow stop. They are not all uniformly the same though. Some might have a slightly greater distance and some slightly less.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Yates Y-Style Bow Stop for Boat Trailers - Heavy-Duty Rubber - 4" Span - 3/8" Shaft
- Boat Trailer Parts
- Guards and Pads
- Bow Stop
- 2 Inch Wide
- Black Rubber
- 2 Inch Long
- Fits 3/8 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Picture of CE Smith Winch Stand # CE31013G Installed on Trailer
- Q&A: How Does Fulton XLT Trailer Jack Wire to Trailer 7-Way
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: How To Bleed Demco DA86 Hydraulic Brake Actuator
- Q&A: Best Trailer Tire Recommendation for a 12 Inch Rim
- Q&A: Goodyear Endurance or Kenda Karrier ST205/75R14 Tire for Boat Trailer at Higher Highway Speeds
- Q&A: Can a Load Range C Tire Be Replaced with a Load Range D Tire
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Determine Tire/Wheel Diameter
- Article: Measuring a Trailer Tire
- Article: How to Measure a Trailer Axle
- Article: Determining Trailer Tongue Weight
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub