Can the Single Axle Trailer Fender # HP66VR Be Drilled Through Back Mounting Flange for Install
Question:
on Redline Trailer Fenders - HP66VR is the back portion of the fender strong enough to be drilled for hanging on a wooden trailer side ?
asked by: Tim
0
Expert Reply:
Yes, the flat edge on the back portion of the Single Axle Trailer Fender # HP66VR that you referenced would be strong enough to be used for drilling through to secure it to a trailer's frame.
That is a very popular method for installing this fender so it would work well.
expert reply by:
Jameson C
0
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Steel - 15" to 16" Wheel - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 16 Inch Wheels
- 13 Inch Wide
- 36 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Trailer Disconnected Error Message
- Q&A: Needing Bearing and Seal Replacement for Lippert Axle
- Article: Trailer Lighting Requirements
- Q&A: Replacement Cover for Trailer Roof Vent AS-13 M-VD0449
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Q&A: Trailer Fenders for 33 Inch BFGoodrich Mud Tires
- Q&A: Replacement Fender for 2016 R-Pod 178
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Choose a Battery Charger
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Double-Eye Trailer Suspension System Review
- Article: Best Tire Chains