Would the Fulton Round, Snap-Ring Swivel Marine Jack Attach to a 3-1/2 inch Tall Trailer Frame
Question:
The tongue is 3-1/2inch tall does this swivel jack work with minimal clearance within the 4 bolts approx.. 1/16..most jacks are 1inch increments at mount holes and 1/2inch clearance is too much at the 4inch mount t locations
asked by: Doug
Expert Reply:
The Fulton Round, Snap-Ring Swivel Marine Jack # FTJ120W0301 is actually a weld-on jack that would work well on your trailer that has 3-1/2 inch tall frame rails. You would just need to take the jack to a qualified welder in your area and he would have it installed on your trailer very quickly.
I attached an install video for this jack for you to check out as well.
Product Page this Question was Asked From
Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jack Recommendation for Shelby # 5856A
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Best Boat Trailer Jacks
- Article: Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Pintle-Hitches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer