What Frame Tube Dimensions B&W Biker Bar Motorcycle Tie-Down System # BWMC2301 Designed to Fit
Question:
What is the diameter of the bar that clamps to the bike? I have a 2013 ultra. I am concerned about clearance loading bike on my trailer. Thanks
asked by: Rick
0
Expert Reply:
The clamp on the B&W Biker Bar Motorcycle Tie-Down System for Trailers # BWMC2301 is designed to attach to motorcycle frames that are between 1-1/8" and 1-1/4".
You will need to measure the diameter of the frame on your 2013 HD Ultra to see if this would fit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Comparing Rota-Flex and Gen-Y 5th Wheel Pin Boxes
- Q&A: Prep-Work for Installing Small Coin Pattern Vinyl Flooring with Adhesive
- Q&A: What Is the Difference Between Biker Bar # BWMC2302B and # BWMC2301B?
- Q&A: Is There an E-Track Adapter for the B&W Biker Bar
- Q&A: Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
- Q&A: Will Using the B&W Biker Bar Put Too Much Stress on the Frame of a Touring Harley
- Q&A: Replacement Bearaing Kit For A 2013 Ranger Tandem Axle Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Tie Down a Motorcycle
- Article: Pintle-Hitches