Where is the Brake Controller Port Located on a 2010 Land Rover Range Rover Sport
Question:
Can you please explain where the pre wired connection port would be on a 2010 Range Rover Sport
asked by: Shane
0
Expert Reply:
You should find your brake controller port underneath the dash somewhere in the center, somewhere above the brake pedal. You would find the port in this location on all Land Rover vehicles equipped with a port. It should be a gray colored plug that will have 6 pins/holes. There should only be 4 or 5 wires.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Brakes for a 2007 Pace Trailer w/ 15 Inch Rims
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Best Brake Controller for a 2014 Fleetwood Bounder Motorhome
- Q&A: Location of Brake Controller Wiring Connector on 2014 Fleetwood Bounder on Ford F-53 Chassis
- Q&A: Brake Controller Recommendation for a 2021 Ford F-53 with Brake Controller Harness
- Q&A: Can Trailer Brakes Be Manually Applied with Tow-Pro RED24FR Liberty Brake Controller
- Q&A: Replacement AC Unit for Dometic Duo-Therm Air Conditioner 630516.331 on 2008 Four Wind Siesta