Troubleshooting Prodigy RF Brake Controller Pairing Issues on a Mercedes
Question:
Cannot get unit to sync. Unit seems operable. I used a Ford as a test and everthing worked perfectly. Mercedes does not sync. Any ideas?
asked by: Mike S
Expert Reply:
The issue you are having is not uncommon for German vehicles. There are a few things you can try to get the unit to pair.
First, If you do not see displayed what the instructions say just keep going through the steps. Sometimes, it will not display what it is supposed to but it will still work if you go through the steps to completion.
If that does not work then you can try taping off the pin in the 5 oclock position at the back of the RF (where the trailer plugs into) using electrical tape. Then go through the installation process.
If that doesn't work you may need a 7-Way to 7-Way adapter, # 20142, which will put more load on the system and could allow the RF to pair up properly.
And if all of the above will not work then have a domestic vehicle with a functioning 7-Way parked right next to your vehicle and pair the RF using that vehicle. Then just move the handheld unit to your vehicle and tow the trailer with it and it will work.
Products Referenced in This Question
Trailer Connector Adapter w/ Lamp-Out Sensor Bypass - 7-Way RV to 7-Way RV - Vehicle End
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 7 Round - Blade
- Plug Only
- 7 Round - Blade
- Tow Ready
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Parts Needed to Tow Trailer With Brakes Using 1992 Dodge D250
- Q&A: 4-Flat Trailer Wiring For 2024 Jeep Wrangler With Tow Bar Wiring