Inner, Outer, and Drop Leg Measurements for Bulldog Square 8,000 Pound Trailer Jack
Question:
What are the dimensions of the tubes and there wall thickness? Does the tube with foot come off?
asked by: Harry
0
Expert Reply:
Bulldog Square Jack # BD180455 has 3 tubes. The outer tube is 3 inches square. The inner leg is approximately 2-1/2 inches square. The outer tube thickness is approximately 1/8 of an inch thick and the inner is between 1/16 and 1/8 inches thick.
The drop leg, which can be removed, is 2 inches square and the wall thickness is the same as the inner leg (between 1/16 and 1/8). The measurements are approximate because they vary ever so slightly due to manufacturing tolerances.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 28-1/2" Lift - 7,200 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 7001 - 8000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Article: Trailer Wiring Diagrams
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: Using NOCO 2 Bank Charger With Parallel Batteries in Truck
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Replacement Axle For 84 Inch 3,500 Pound Dexter Axle
- Article: Trailer Hitch Receiver Sizes
- Q&A: Replacement Antennas for Voyager WiSight Wireless Backup System
- Q&A: Replacement Kwikee Electric Steps for a 2005 Jayco Greyhawk 31SS
- Article: Stability Control for Heavy Duty Vehicles
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)