Troubleshooting Roadmaster Invisibrake that Shows Zero Pressure
Question:
What causes the invisible brake to loose the air pressure I after setting it. Can stop the motor home for 10 minutes and the pressure will drop.
asked by: Kenneth T
0
Expert Reply:
Are you sure the pressure is being lost and not actually maxed out? If the air pressure of the InvisiBrake part # RM-8700 is set to the maximum the gauge will actually spin completely around the gauge and show zero.
To confirm that the compressor is operating properly, pull out on the brake pressure adjustment knob and rotate it counterclockwise. The needle will move as you lower the pressure. Adjust to desired pressure setting.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Article: Diode Installation Instructions for Dinghy with Combined Tail Light Wiring
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Q&A: Where to Install Diodes when Installing Roadmaster Invisibrake with Tow Bar Lighting
- Q&A: Troubleshooting Roadmaster InvisiBrake Lack of Air Pressure
- Search Results: invisibrake 8700
- Q&A: How to Perform Regulator Reset Procedure on Roadmaster Even Brake System
- Shop: Roadmaster Stop Light Switch Kit
- Shop: Roadmaster Smart Diodes for Variable Voltage Incandescent Tail Lights - Qty 2
- Shop: Roadmaster Smart Diode 7-Wire to 6-Wire Wiring Kit for Variable Voltage Incandescent Tail Lights
- Shop: Roadmaster Stop Light Switch Kit - Chevrolet Equinox / GMC Terrain
- Shop: Base Plate for Tow Bar
- Shop: Replacement Cable for Roadmaster InvisiBrake Flat Tow Brake System
- Q&A: Factory PSI Setting for Roadmaster InvisiBrake
- Q&A: Troubleshooting Invisi Brake From Roadmaster Where Compressor Does Not Come On
- Shop: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Q&A: Should Steering Wheel be Unlocked or Locked While Flat Towing
- Q&A: Determining Braking Pressure on Roadmaster InvisiBrake Supplemental Braking System # RM-8700
- Search Results: invisibrake
- Video: Best 2018 Jeep Jk Wrangler Base Plate Options
- Video: Roadmaster InvisiBrake Braking System Installation - 2014 Jeep Wrangler
- Video: etrailer Invisible Base Plate Kit Installation - 2018 Jeep JK Wrangler Unlimited
- Video: Roadmaster InvisiBrake Supplemental Braking System Installation - 2018 Jeep JK Wrangler Unlimited
- Video: Roadmaster InvisiBrake Braking System Installation - 2021 Jeep Wrangler
- Search Results: roadmaster invisibrake
- Search Results: invisibrake parts