Installing Ventline Vanair Trailer Roof Vent On 2014 Nissan NV200 Roof with Ridges
Question:
I am interest to vent line roof fan VP-543SP and kit RVIKIT100 which I like to install to my Nissan NV200 Cargo van but the roof sheet metal has factory bend Metal foaming a u-shape design. It measure about 6inch of length apart. Your part requires 6-1/4inch of opening and flange measures 8-5/8 inch so the flange Will not sit in flush to the roof metal and seal completely, air and water may be leak into internal Cargo, is there any suggestion to install it? Bend break On the roof is about 1/8inch height.
asked by: Keith T
Helpful Expert Reply:
In order to seal the Ventline Vanair Trailer Roof Vent # VP-543SP on your 2014 Nissan NV200 I recommend using the sealant that comes in the Installation Kit # 344270KITW. This sealant is waterproof and will keep the elements out of your van. The sealant will fill the space between the roof of your van and the vent.
I spoke with Ventline about installing the Vanair on a cargo van with a ridged roof. They do not have any recommendations or suggestions for installing the vent on the roof of your 2014 Nissan NV200.
Products Referenced in This Question
Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White
- Accessories and Parts
- RV Vents and Fans
- Vent Install Kit
- LaSalle Bristol
more information >
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 2-3/8 Inch
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Continue Researching
- Article: Replacement Automotive Lighting
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Recommended Replacement Roof Vent For An Airstream Flying Cloud 23D Travel Trailer
- Q&A: Replacement Front Landing Gear Leg for Lippert Ground Control 3.0
- Q&A: How To Install MaxxFan Dome Roof Vent On Thin Metal Roof
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Replacement Al Ko 10k Brake Calipers and Brake Pad Recommendation
- Q&A: Circuit Board Replacement for MaxxFan 4751KS
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: What are the Common Types of Propane Fittings Used on RVs?